Francis Francis illy Y1.1 Touch Manuel D'instructions page 24

INDICATION
The buttons light up in sequence
+
Lit
+
The espresso button fl ashes
+
The long espresso button fl ashes
Slow fl ashing
Dimming of illumination
Steadily lit (only the espresso button)
+
Flash alternately
Steadily lit (only the long coffee button)
+
Flash alternately
+
Rapid fl ashing
All manuals and user guides at all-guides.com
24
MACHINE STATUS
The machine has been turned on and is warming up.
The machine has reached the right temperature for brewing.
The machine is brewing an espresso.
An espresso is being programmed.
The machine is brewing a long espresso.
A long espresso is being programmed.
The machine is in the Power Save mode. The machine switches into Power Save
after 60 minutes when not used. To start the machine again just touch any button.
The machine needs to be descaled.
The machine is indicating that the descaling cycle has been selected. In this status
the tank should contain a descaling solution.
The machine is indicating that the fi rst part of the descaling cycle is in progress.
Descaling solution is being run through the machine.
The espresso button alone fl ashes progressively.
The machine is indicating that the fi rst part of the descaling is over.
The tank must be rinsed out and fi lled with fresh drinking water.
The machine is indicating that the second part of the descaling cycle is in prog-
ress. Water is being run through the machine to rinse out the circuit.
The long espresso button alone fl ashes progressively.
The machine has a malfunction. Turn it off and back on again after 30 seconds. If
the fault is signaled again, contact a service center.