Hilti TE 30 Mode D'emploi page 20

All manuals and user guides at all-guides.com
▶ Operation is permissible only when connected to a power source providing a voltage and frequency in
compliance with the information given on the type identification plate.
3.3 Description of the device
3.3.1 Active Vibration Reduction (AVR)
TE 30-AVR
TE 30-C-AVR
The combihammer is equipped with an Active Vibration Reduction (AVR) system, which reduces vibration
significantly.
3.4 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
Note
For safe, reliable operation, use only genuine Hilti spare parts and accessories.
accessories and consumables approved by Hilti for use with this product can be found at your Hilti
Center or at www.hilti.com.
4 Technical data
4.1 Combihammer
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
The information given applies to a rated voltage of 230 V. The data may vary in the event of deviations from
the rated voltage and for country-specific versions. Please refer to the power tool's rating plate for details of
its voltage, frequency, current and input power ratings.
Rated current in- 230 V
put
Weight in accordance with
EPTA procedure 01/2003
Single impact energy in ac-
cordance with EPTA proce-
dure 05/2009
Ø hammer drill bits
Ø drill bits for wood
Ø drill bits for metal
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one electric tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the electric
tool. However, if the electric tool is used for different applications, with different accessory tools, or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This may significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintenance of the electric tool and the accessories, keeping the hands warm,
organization of work patterns.
14
Model
TE 30
4.0 A
4.0 kg
3.3 J
5 mm ... 28 mm
5 mm ... 20 mm
3 mm ... 13 mm
TE 30­AVR
4.0 A
4.2 kg
3.3 J
5 mm ... 28 mm
5 mm ... 20 mm
3 mm ... 13 mm
Spare parts,
TE 30­C­AVR
4.0 A
4.2 kg
3.3 J
5 mm ... 28 mm
5 mm ... 20 mm
3 mm ... 13 mm