Rosewill RHTB-11003 Mode D'emploi page 5

FIXED WALL MOUNT FOR LCD, PLASMA, and LED DISPLAYS
4. Insert a concrete anchor (C) into each hole so that it is flush with the
concrete surface. A hammer can be used to lightly tap the anchors into
place if necessary.
NOTE: If the concrete wall is covered by a layer of plaster or drywall, the
concrete anchor must pass completely through the layer to rest flush with
the concrete surfa ce.
5. Place the wall plate back against the wall and attach it using the M6.3 x 63
screws (A) and washers (B) provided. Do not over-tighten these screws
and do not release the wall plate until both screws are in place. Ensure that the wall plate
remains level after all screws are secured.
Part 2 – Attaching the Mount Arms to the Display
IMPORTANT! Use extra care during this part of the installation. If possible, avoid placing your display facedown
as it may damage the viewing surface.
NOTE: This mount comes with a selection of different screw diameters and lengths to accommodate a wide
variety of display models. Not all of the hardware in the kit will be used. If you cannot find the appropriate screw
size in the kit provided, consult the manufacturer of your display for more information.
1. Determine the correct length of screw to use by examining the back of your display:
A.
B.
2. Determine the correct diameter of screw to use by carefully trying one of each size (M4, M6 and M8)
from the hardware kit. Do not force any of the screws – if you feel resistance stop immediately
and try a smaller diameter screw.
3. Attach the mount arms to the back of your display using the screws identified in steps 1 and 2:
A.
B.
Part 3 – Final Assembly
1. With the help of another person, carefully lift your display and place it on the mount. Do not release
the display until the mount arms have securely hooked onto the mount.
If the back of your display is flat and the mounting holes are flush with the surface, you will
use the shorter screws (D, F, or H) from the hardware kit.
If the back of your display is curved, has a protrusion, or if the mounting holes are
recessed, you will need to use the longer screws (E, G, or I) and may also need to use the
spacers (K).
If you are using the M4 or M6 screws you will also need to use the M6 washers (J). M8
screws do not require washers.
If you are using the longer screws on a display with a curved or recessed back, you may
also need to use the spacers (K). Use one spacer or two spacers stacked as needed.
Only use a spacer if necessary.
( )
4
RHTB-11003 User Manual
( )