Publicité
Les langues disponibles
Les langues disponibles
FIXED WALL MOUNT FOR LCD, PLASMA, and LED DISPLAYS
HARDWARE KIT
(A) M6.3 x 63 Screw (x2)
(B) Washer (x2)
(C) Concrete Anchor (x2)
(D) M4 x 12 Screw (x4)
(E) M4 x 20 Screw (x4)
(F) M6 x 12 Screw (x4)
INSTALLATION
Part 1A – Mounting to the Wall (Drywall)
IMPORTANT! For safety reasons, this mount must be secured to at least two wood studs no less than 16" apart.
The studs must be capable of supporting the combined weight of the mount and display.
1.
Use a high quality stud finder to locate two adjacent studs where you
wish to install y our mount. Mark both edges of each stud to help identify
the exact center.
NOTE: You must use the center of each stud to avoid cracking or
splitting the wood during installation.
2.
Place the wall plate against the wall over the marked studs. Make sure it
is level.
3.
While another person holds the wall plate in position, mark two locations
(one per stud) for securing the mount to the wall.
Set the wall plate aside and drill a 3 mm (1/8") pilot hole at each marked location.
4.
5.
Place the wall plate back against the wall and
attach it using the M6.3 x 63 screws (A) and
washers (B) provided. Do not over-tighten these
screws and do not release the wall plate until
both screws are in place. Ensure that the wall
plate remains level after all screws are secured.
Part 1B – Mounting to the Wall (Concrete)
IMPORTANT! For safety reasons, the concrete wall must be capable of supporting the combined weight of the
mount and the display. The manufacturer takes no responsibility for failure caused by walls of insufficient strength.
1.
Place the wall plate against the wall in the desired location. Make sure it is
level.
2.
While another person holds the wall plate in place, mark two locations on
the wall for s ecuring the mount.
Set the wall plate aside and drill an 8 mm (5/16") hole at each marked
3.
location. Remove any excess dust from the holes.
(G) M6 x 30 Screw
(x4)
(H) M8 x 12 Screw
(x4)
(I) M8 x 30 Screw (x4)
(J) M6 Washer (x4)
(K) Spacer (x8)
3
RHTB-11003 User Manual
Publicité
