Publicité
Les langues disponibles
Les langues disponibles
STAND REMOVAL AND WALL MOUNTING
Tools Needed: Phillips screwdriver
IMPORTANT NOTE:
Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish.
Wall mounting of the HDTV must be performed by a skilled person.
DP19649
1
Remove the four (4) screws securing the foot
stand. CAUTION: Hold the stand firmly as you
remove the last screw.
2
Use the screws you removed when dettach-
ing the stand to secure the HDTV to a wall
mounting kit (not included.)
VESA standard interface: 100 x 100
Mounting screws measurements:
M4 (4mm) Diameter, Length—10mm (maximum)
GETTING STARTED
Install batteries in the remote control
( 2 "AA", not included)
PRECAUTIONS
To ensure safe operation, please observe
the following precautions:
• Replace both batteries at the same
time. Do not use a new battery with
a used battery.
• There's a risk of explosion if a battery
is replaced by an incorrect type.
• Do not expose the Remote Control unit to moisture
or heat.
• Be sure to match the "+" and "
batteries with marks inside the remote control.
All manuals and user guides at all-guides.com
1
–
" signs on the
Need help?
(OPTIONAL)
DP26649
Remove the four (4) screws securing the foot
stand. CAUTION: Hold the stand firmly as you
remove the last screw.
2
Use the screws you removed when detach-
ing the stand to secure the HDTV to a wall
mounting kit (not included.)
VESA standard interface: 200 x 200
Mounting screws measurements:
M6 (6mm) Diameter, Length—16mm (maximum)
ANTENNA CONNECTION FOR
OFF-AIR SIGNALS OR CABLE
ANTENNA
CABLE
NOTE: The tuner in this HDTV can receive digital and
analog off air signals from an antenna. It can also
receive analog or ClearQAM cable channels from
a direct Cable TV connection.
www.sanyoctv.com
ANALOG / DIGITAL
ANTENNA IN
5
1-800-877-5032
Publicité
