Setting Input Source; Line Output & Aux In - Kicker KPB1 Manuel D'utilisation

Setting Input Source

Short Press the SOURCE button to switch between
Bluetooth (blue) and AUX IN (red) input sources.
To enter Bluetooth Pairing Mode, Long Press the
SOURCE button while in Bluetooth mode. The
STATUS LED will begin to flash blue. You may exit
pairing mode at this stage by short pressing the
SOURCE button.
To finish pairing, from your audio device select either
'KPB1 KICKER' or 'KPB2 KICKER'. When successfully
connected, the STATUS LED will be solid blue. When
the PowerBar powers on in, or enters, Bluetooth
mode, it will automatically begin to search for and
connect with the last connected device.
Line Output & AUX IN
To use an external audio device as your input source,
connect it to the AUX IN jack using a 1/8" (3.5mm)
AUX cable, then set your input source to AUX IN.
To send a line-level signal, connect a 1/8" (3.5mm)
AUX cable from the Line Output of the KPB to your
external audio device's line-level input.
English
LINE-OUT
gray
AUX IN
black
10