Télécharger Imprimer la page

Craftsman C950-52133-0 Manuel D'utilisation page 18

Publicité

MAINTENANCE
MAINTENANCE CHART
SNOWTHROWER
After Each Use
Remove the snow and slush off snowthrower to prevent
freezing of controls
Every 8 Hours or Daily
Perform snowthrower safety tests
Every 25 Hours or Annually *
Check tire pressure
Check snowthrower for loose hardware
See Dealer Annually to
Lubricate control levers and linkages
Lubricate deflector hinge
Lubricate deflector motor (if equipped)
Lubricate chute rotation gear (if equipped)
EMISSIONS CONTROL STATEMENT
Maintenance, replacement, or repair of the emissions control de-
vices and systems may be performed by any non-road engine re-
pair establishment or individual. However, to obtain "no charge"
emissions control service, the work must be performed by a fac-
tory authorized dealer. See the Emissions Warranty.
ENGINE MAINTENANCE
Check Crankcase Oil Level - Before starting engine and after
each 8 hours of continuous use. Add the recommended motor oil
as required.
NOTE: Over filling the engine can affect performance. Tighten
the oil fill cap securely to prevent leakage.
Change Oil - Every 50 hours of operation or at least once a year,
even if the snowthrower is not used for fifty hours. Use a clean,
high quality detergent oil. Fill the crankcase to FULL line on dip-
stick (A, Figure 12). Be sure original container is marked: A.P.I.
service "SF" or higher. Do not use SAE10W40 oil (as it may not
provide proper lubrication). See Chart for oil recommendations.
All manuals and user guides at all-guides.com
ENGINE
First 5 Hours
Every 8 Hours or Daily
Every 50 Hours or Annually *
See Dealer Annually to
* Not required unless there are problems with engine
Drain Oil – Position snowthrower so that the oil drain plug (A, Fig-
ure 13) is lowest point on engine. When the engine is warm, re-
move oil drain plug and oil fill cap and drain oil into a suitable
container.
Replace oil drain plug and tighten securely. Refill crankcase with
the recommended motor oil.
* Below 40°F (4°C) the use of SAE 30 will result in hard starting.
** Above 80°F (27°C) the use of 10W-30 may cause increased oil consumption. Check
18
Change engine oil
Check engine oil level
Change engine oil
Check muffler and muffler guard.
Replace spark plug
Check valve clearance
performance.
oil level more frequently.

Publicité

loading