Publicité
Install Drift Cutters
1. Remove fastener and drift cutter from auger housing
(if equipped) (N).
2. Insert tab of drift cutter into lower hole on outside of auger
housing (O).
3. Reinstall fastener as shown (P).
4. Repeat steps to install the opposite drift cutter.
P
O
4
All manuals and user guides at all-guides.com
N
Adjust Skid Shoes
1. Adjust the skid shoes so that the scraper bar has 1/8"
- 3/16" clearance above a hard surface or 1" clearance
above a gravel surface (R).
7/16"
R
1/8" - 3/16"
(3 mm - 5 mm)
1"
(2,5 cm)
Publicité
