Publicité
Les langues disponibles
Les langues disponibles
Blade block
Cleaning lever
Moving blade
Stationary blade
Mounting hook
1 mm comb attachment
(1 mm (1/32˝))
Trimming height comb
attachment
(2 mm (5/64˝) to 10 mm
(13/32˝))
3 mm adjustment buttons
Trimming height window
Trimming height indication
mark
Trimming height
adjustment lever
Charging the clipper
Perform the following steps to charge the clipper if it seems to lose
speed.
1
1
Turn off the clipper and insert
it in the AC adaptor until it
clicks as illustrated.
The clipper will not charge unless the
side terminals are in contact with the
charging terminals.
Wipe off any water droplets on the
side terminals.
If you charge the clipper with power
switch turned on, it will start working
when you remove from the AC adaptor.
AC adaptor (RE7-70)
Charging terminals
Charge indicator lamp
Power cord
Power plug
Accessories
Cleaning brush
Oil
2
1
2
2
Put the power plug into a household outlet.
The charge indicator lamp glows red.
Charging time differs depending on the rated voltage.
Charging time
When charging the clipper for the irst time or when it has
not been in use for more than 6 months, the charge
indicator lamp may not glow for a few minutes, or the
operating time may shorten. Please charge it for more than
30 hours in such cases.
3
3
Disconnect the power plug after charging is
completed.
To keep charging the battery will not affect battery
performance.
Recommended ambient temperature for charging is
0 - 35 °C (32 - 95 °F). The battery may not charge properly
or not at all under extreme low or high temperatures.
The charge indicator lamp glows and stays on until the
power plug is disconnected from a household outlet.
A full charge supplies enough power for approximately
40 minutes of use.
Note:
You cannot operate the clipper while charging.
Approx. 20 hours
110 V
Approx. 15 hours
120 V
9
Publicité
