Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Hose
Clamp
Regulator
Manifold
5.
Remove pump mounting screws
securing pump (one on each
side).
Pump Mounting Screw
Before you store the air compressor,
make sure you do the following:
1.
Review the "Maintenance"
section on the preceding
pages and perform scheduled
maintenance as necessary.
2.
Set the On/Off switch to OFF (O)
and unplug unit.
3.
Risk of Flying
Objects. Pull the regulator knob
out and turn counter-clockwise
to set the outlet pressure to
zero when removing hose or
accessories to prevent hose
backlash.
4.
Remove the air tool or accessory.
5.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately 20
psi. Release safety valve ring.
6.
Drain water from air tank by
opening drain valve on bottom of
tank.
6.
Carefully slide pump from
brackets and out of the way.
7.
Using an adjustable wrench or
5/8" wrench remove the regulator
manifold.
8.
Apply pipe sealant to new
regulator manifold and assemble,
tighten with wrench.
9.
Reapply pipe sealant to gauges,
quick connect, and safety valve.
10. Reassemble all components in
reverse order of removal. Make
sure to orient gauges to read
correctly and use wrenches to
tighten all components.
STORAGE
condense in the air tank. If not
drained, water will corrode and
weaken the air tank causing a risk
of air tank rupture.
7.
After the water has been drained,
close drain valve by turning
clockwise.
NOTE: If drain valve is plugged,
release all air pressure. The valve
can then be removed, cleaned, then
reinstalled.
8.
Protect the electrical cord and
air hose from damage (such as
being stepped on or run over).
Wind them loosely around the
compressor handle.
9.
Store the air compressor in a
clean and dry location.
15 - ENG
Pump shown
moved out of
the way
Regulator
Manifold
Risk of Bursting.
Water will
A18760
Publicité
