GE 29897 Mode D'emploi page 13

3. Once the first digit is set, press ENTER.
4. Repeat steps 2-3 until all the digits of the area code are set.
5. When finished, press ENTER to confirm. The unit beeps.
NOTE: To skip to the next setting, press MENU. To exit setup, press EXIT.
TIP: You can use the keypad to enter all the digits in one step. To
enter 317, press 3,1, and 7. Then press ENTER.
Setting the Incoming Message Length
This setting allows you to set the maximum length of time allowed for a single
incoming message. You can choose from 1-4 minutes.
1. If you just adjusted the Local Area Code menu, skip to step 2. If you haven't
adjusted any other setting, press and release the MENU button until MESSAGE
LENGTH is displayed.
2. Use NEXT or REVIEW or press the keypad number (1-4) for the desired setting.
3. When finished, press ENTER to confirm. The unit beeps.
NOTE: To skip to the next setting, press MENU. To exit setup, press EXIT.
Setting the Rings to Answer
This setting allows you to set the number of rings before the unit answers a call. You
can choose from 2-8 or Toll Saver (see "Toll Saver.")
1. If you just adjusted the Message Length menu, skip to step 2. If you haven't
adjusted any other setting, press and release the MENU button until SET RINGS TO
ANS is displayed.
2. Use NEXT or REVIEW or press the keypad number (2-8, Toll Saver) for the desired
setting.
3. When finished, press ENTER to confirm. The unit beeps.
NOTE: To skip to the next setting, press MENU. To exit setup, press EXIT.
All manuals and user guides at all-guides.com
1