emerio DH-122844 Mode D'emploi page 9

USE
Plug in the appliance.
Power button
Press the power button to turn on the appliance. The air outlet cover opens automatically.
Press the button again to turn off the appliance. The air outlet cover closes automatically.
Mode button
Press the mode button to select your desired mode: dehumidification mode, fan mode or clothes drying mode.
1. Dehumidification mode: the indicator light of "DEH" illuminates. The fan speed can be switched between
low and high. The humidity can be set between 30-90%RH or set to "CO" (Continuous) or "AU" (Comfort).
Press the button "
further operations. The digital display will turn back to show the room humidity.
1) When the room humidity ≥ set humidity + 4%, the compressor starts working and the fan keeps running
at the set speed. After dehumidifying, when the room humidity ≤ set humidity - 3%, the compressor is
turned off and the dehumidifying is stopped. Once the room humidity ≥ set humidity + 4% again, the
compressor resumes working. Thus, the indoor humidity can be maintained at the set humidity
according to the above cycle operations.
2) When the room humidity does not reach the set humidity (-3%), the indicator light of "OK" on the control
panel is off. When the room humidity reaches the set humidity (-3%), the indicator light of "OK" will be
on.
3) When the set humidity is "CO", the compressor runs continuously without the limitation of the set
humidity, and the fan speed is adjustable.
4) When the set humidity is "AU", the appliance will work as following.
- Room temperature is below 5℃, the appliance stops working.
- 5℃ ≤ room temperature ≤ 20℃, the appliance works to reach the humidity 60%RH.
- 20℃ ≤ room temperature ≤ 27℃, the appliance works to reach the humidity 55%RH.
- Room temperature is above 27℃, the appliance works to reach the humidity 50%RH.
- Room temperature ≥ 27℃, the fan speed cannot be adjusted and the unit works at high fan speed
by default.
2. Fan mode: the indicator light of "FAN" illuminates. The compressor does not work; the fan speed can be
switched between low and high. The humidity cannot be set and the room humidity is shown on the digital
display.
3. Clothes drying mode: the indicator light of "LAUNDRY" illuminates. The compressor keeps running
continuously. The fan speed cannot be adjusted and the unit works at high fan speed by default. The humidity
cannot be set and the room humidity is shown on the digital display.
Increasing/decreasing setting buttons
1. Press the buttons "
2. Press and hold the buttons "
on the digital display. The display will last for approx. 5 seconds.
Fan speed button
Press the fan speed button to select low or high fan speed. The corresponding indicator light will illuminate.
"/" " to adjust the setting. The setting will be in effect in approx. 10 seconds with no
"/" " to adjust the setting of humidity.
" and " " at the same time for 2 seconds to check the room temperature
- 8 -