Publicité
Les langues disponibles
Les langues disponibles
Empty the water tank
1. Draw out the water tank gently by holding the concave part at the both sides.
2. Discard the collected water.
3. Install the water tank back by pushing it horizontally and gently. The handle of the water tank cover should
lie down.
Caution:
1) Do not remove the float from the water tank. The water full sensor will no longer be able to detect the water
level correctly without the float and water may leak from the water tank.
2) Do not use the detergents, steel velvet, chemical treated dusting cloth, gasoline, benzene, thinner or other
solvents to clean the water tank.
3) Put the water tank back into the appliance tightly with both hands. If the water tank is not placed in the right
position, the water full sensor will still be activated, and the dehumidifier will not work.
Continuous water drainage
Plug the provided plastic pipe to the continuous drainage outlet, and the condensed water will be continuously
drained out through this outlet instead of collection in the water tank. Make sure the pipe is installed at a
downhill way to let the water continuously flow out.
- 10 -
Publicité
