Publicité
Les langues disponibles
Les langues disponibles
CLEANING AND MAINTENANCE
The appliance must be regularly cleaned to prolong its life and keep it function properly.
Warning: Before performing any cleaning, turn off the unit and unplug it to avoid electrical shocks. Do not use
hot water or chemical solvents for cleaning.
1.
Regularly, clean the water tank with cold or warm water and dry with a soft cloth to avoid any mildew.
2.
Clean the surface of the appliance using a moist cloth. Do not use detergents or abrasive sponges that can
cause damage to the plastic surface.
3.
Clean the filter as described in the following section.
4.
When the unit will not be used for a long time:
1)
Empty and dry the water tank, and then install it back.
2)
Clean the filter.
3)
Place the appliance upright and avoid the direct sunlight.
Filter
There is a filter set at the back of the appliance that must be removed and cleaned regularly. The dehumidifying
capacity may reduce when the filter set is clogged.
Pull out the filter from the bottom to take it off the appliance.
It is recommended to wash at least once every two weeks of continuous use.
If the filter is not dirty, just vacuum the dust off it.
If the filter is dirty, simply wash with cold water or warm water not exceeding 40 degrees; do not use
chemical solvents or hot water.
Dry the filter well before assembly.
Notice:
In order to prevent the filter from being deformed, it needs to be air-dried naturally after cleaning. Never use a
dryer or heater of any kind. Do not use alcohol, gasoline, benzene or other chemical solvents to clean the filter.
TROUBLE SHOOTING
Status
Dehumidifier is not
working
Dehumidification
function does not
work
No wind
Possible reason
Is the power plug unplugged?
Is the water tank full? Or is the water
tank placed in the wrong position?
Is the room temperature above 35℃
or under 5℃?
Is the air filter blocked?
Are the air outlets or air inlets
blocked?
Is the air filter blocked?
Insert the power plug into the socket.
Drain the standing water in the tank
and put the tank back in the correct
position.
The protection device is started and
the machine cannot work.
Clean the air filter.
Clean up any items that block the air
outlet or air inlet.
Clean the air filter.
- 11 -
Solutions
Publicité
