Publicité
Les langues disponibles
Les langues disponibles
The Brondell H20+ water pitcher filtration system reduces many contaminants from tap water.
Influent Challenge
Concentration
Substance
Average
NSF/ANSI Standard 42 - Aesthetic Effects
Chlorine
1.99 ppm
2.0 +/- 0.2 ppm
NSF/ANSI Standard 53 - Health Effects
Copper
2.8 ppm
3.0 +/- 0.3 ppm
Copper
3.0 ppm
3.0 +/- 0.3 ppm
Cadmium
31 ppb
30 +/- 3.0 ppb
Cadmium
29 ppb
30 +/- 3.0 ppb
*The US EPA levels are Maximum Contaminant Levels (MCLs) and are the same as the NSF Maximum Permissible
Product Water Concentrations listed in NSF / ANSI 42 and 53 unless noted otherwise.
= US EPA Action Level N/A = Not Applicable
a
Product Specifications:
*Rated Filter Capacity: 42 Gallons
*Filter Capacity per Day: 2.6 Gallons
Estimated Cost of Replacement element: HF-10 Water Pitcher Filters, Pack of 3 - $16.95
Tested and Certified by WQA against
NSF/ANSI 42 for the reduction of Aesthetic
Chlorine and to NSF/ANSI 53 for the
reduction of Cadmium and Copper as
verified and substantiated by test data.
Claims are based on testing performed under standard laboratory condition according to NSF/ANSI 42 and 53
for reduction of the substances listed. The concentration of the indicated substances in water entering systems
was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as
specified in NSF/ANSI 42 and 53. The contaminants or the substances removed or reduced by this water
treatment device are not necessarily in all user's water. The performance of the filter may vary based on local
water conditions.
Do not use with water that is unsafe or of unknown quality without adequate disinfection before or after the
system. Individuals requiring water of specific microbiological purity should consult their physician.
The Brondell H20+ Filter Pitcher processes approximately 42 gallons/160 liters of water. For optimal
performance, replace the filter when it exceeds filtering capacity. Refer to the Use and Care portion of the
Owner's Manual for this pitcher for proper unit operation and maintenance requirements. Hot water should not
be used with the Brondell H20+ Pitcher Filter (Maximum 85˚F / 33˚C - Minimum 29˚F / .06˚C).
Performance Data Sheet
Filter
Removal
Effluent
Efficiency
Average
Average
NSF Std
0.04 ppm
98%
0.26 ppm
90.8%
0.43ppm
85.6%
1.3 ppb
95.8%
.75 ppb
97.4%
Model: H10-W, H10-B
Filtered Water Pitcher
Replacement Part Number: HF-10
Minimum %
Influent Water Test Conditions
reduction
requirement/
Hardness
Alkalinity
Max effluent
(ppm CaCO
)
(ppm CaCO
concentration
3
50% Reduction
N/A
1.3 ppm
16
a
1.3 ppm
112
a
5 ppb
14
5 ppb
103
Temp
pH
)
(˚C)
3
N/A
22
7.82
18
22
6.50
111
22
8.50
12
22
6.55
108
22
8.56
Publicité
