brondell H2O+ H10-W Manuel De L'utilisateur page 5

5. Prepare and Install the Filter:
**Use cold or room temperature water.
a. Wash your hands and then remove the Filter from its package. Soak it upright in
water for 10 minutes.
b. Rinse the Filter under running water for 10 seconds.
c. Press it firmly down into the tube of the Reservoir to ensure a tight seal.
6. Attach the Lid.
7. Fill the Pitcher:
** Always use cold or room temperature water when filling the Pitcher.
Press down on the tab next to the Filter Life Indicator to open the hole in the Lid. Fill
the Reservoir with water and allow all the water to filter through. Discard the water
and repeat. The third pitcher of water is ready for drinking.
• Always allow all the water in the Reservoir to pass through the Filter before pouring the water.