Publicité
Les langues disponibles
Les langues disponibles
8. If the room temperature is low(under 64f), The ready light
9. Plug the laminator in after verifying the correct voltage.
HOT LAMINATING PROCEDURE
1. Turn the power switch to the hot position.
The power indicator will light. Allow approximately 10 minutes to preheat.
When the proper temperature is reached, the "ready" light will go on.
2. Place the item to be laminated into the laminating pouch.
3. Insert the pouch film into the front opening of your laminator.
Be sure to center the laminating pouch as it is inserted.
4. The item will autormatically feed out through the rear of the
laminator.
(SAFETYNOTE: The laminated item may be too hot to touch.)
5. If the item is not completely laminated, repeat steps 3-5.
NOTE: Your finished laminated item will be hot,and will easily bend.
To keep your laminated item flat , place on flat surface and allow to cool.
All manuals and user guides at all-guides.com
may take longer to come on.
Failure to comply with the above information could result in
serious injury.
5
ES-400C
Publicité
