MOTION BLINDS CM-06 Mode D'emploi page 9

Pair a remote
5
Pair a remote control that is able to program blinds. In this manual
CM-12 is displayed.
Shortly press the program button on the
5.1
motor. The blind will start stepping, indicating
that program mode has been activated.
(The blind remains stepping until the program
mode is de-activated.)
Select a desired channel for the blind using the
5.2
channel selection button on the remote control.
Press the pair button on the back of the remote
5.3
control to pair the blind to the selected channel.
The blind will shortly stop stepping indicating
that the remote has been paired to the blind.
Repeat steps 5.1 - 5.3 to remove a blind from
a channel.
End limits must be programmed to use a blind properly and to prevent it from being damaged.
Proceed to step 11 if end limits are already set.
Check direction of rotation
6
WARNING:
Stop the blind before reaching
the end positions.
Manual CM06V2.indd 9 Manual CM06V2.indd 9
MOTION BLINDS CM-06 LI-ION TUBULAR MOTOR
risk of damage.
Shortly
press
Channel
Selection
Shortly press the down button to check if the
6.1
blind unrolls the right way. If the blind moves
up the direction of rotation must be changed.
Simultaneously press the up and down button
6.2
to change the direction of rotation.
Channel
indicator
Pair
Button
Up
Down
2-7-2021 12:09:32 2-7-2021 12:09:32
9