MOTION BLINDS CM-06 Mode D'emploi page 13

Operate the blind
13
Operate to favourite position
14
Manual CM06V2.indd 13 Manual CM06V2.indd 13
MOTION BLINDS CM-06 LI-ION TUBULAR MOTOR
Pull control: pull once to move the blind to the end
positions. Pull again to stop the blind.
Direct control off : The blind will tilt slowly and lift at normal
speed.
Direct control on : The blind will tilt and lift at normal speed.
Remote control: Choose the channel to which the blind
has been paired using the channel button.
Direct control off : Shortly press the up or down button
to slightly tilt the blind. Hold the up or down for 2
seconds and the blind will move to the end position.
Press the center button to stop the blind.
Direct control on : The blind will move to the end
position by a single press on the up or down button.
Press the center button to stop the blind.
Pull control: Pull and hold to move the
blind to the favourite position.
Remote control: Hold the center button to move the
blind to the favourite position.
Center
Channel
Selection
Center
3 s
Up
Down
13
2-7-2021 12:09:40 2-7-2021 12:09:40