MOTION BLINDS CM-06 Mode D'emploi page 14

Reset favourite position
15
De-activate direct control
16
14
When pressing the up or down button on the remote control the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be de-activated. Now, the blind only directly moves to its end
positons when the up or down button is held longer than two seconds.
The motor will also tilt slowly when using the pull function.
Press the program button on the motor to activate
16.1
program mode. The blind starts stepping.
Hold the program button until the blind stops stepping (approximately 5 seconds)
16.2
to de-activate or re-activate direct control.
Manual CM06V2.indd 14 Manual CM06V2.indd 14
MOTION BLINDS CM-06 LI-ION TUBULAR MOTOR
Move the blind to a desired favourite position.
15.1
Press the program button on the motor to activate
15.2
program mode. The blind starts stepping.
Hold the center button to save this favourite
15.3
position. The blind shortly stops stepping indicating
the favourite position has been saved succesfully.
Press the program button on the motor to de-activate
15.4
program mode. The blind stops stepping.
Shortly
press
Center
5 s
2-7-2021 12:09:41 2-7-2021 12:09:41