All manuals and user guides at all-guides.com
Fax +1 305 430 9692
BATTERY
If your appliance does not work properly, it is probably because the
batteries are discharged. In that case, replace them by new ones of
the same type (see BEFORE USE).
Please eliminate the old batteries in an environmentally friendly way.
TROUBLESHOOTING
If the mill does not grind, please check that the batteries are installed
correctly and are not discharged. For best results we recommend
alkaline batteries.
If the mill gets stuck during use (motor produces hum, but internal
shaft does not turn and no pepper is ground], gently shake the mill or
tap the mill gently on a hard surface, to remove the stuck pepper or
salt.
To remove deeply stuck peppercorn, remove the upper lid as if for
re-filling the mill, turn the coarseness setting to its coarsest, and tap
lightly on a hard surface until all the peppercorn is released. Re-
adjust coarseness setting to the desired level once done and
replace upper lid.
Note: Too fine a grind setting may not enable salt or pepper to be
ground. If this is the case, set the grinder to a coarser setting (see
above).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
4
Assembly page 4/16
Team
Print only
PPG 26914 - 120501