Black & Decker 1VPX Mode D'emploi page 10

90521013 VPX Inflator manual
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
Problem
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
For assistance with your product, visit our website www.blackanddecker.com for the location of
the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
All manuals and user guides at all-guides.com
7/31/07 10:47 AM Page 10
TROUBLESHOOTING
Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature.
• Battery pack too hot or too cold.
10
Possible Solution
• Check battery pack
installation.
• Check battery pack - one
or both batteries may not be
charged. Use LED depleted
battery indicator to determine
which one is depleted.
charger until red LED
appears.
• Plug charger into a
working outlet. Refer to
"Important Charging Notes"
for more details.
• If chargers are daisy
chained together check
all connections.
• Check current at
receptacle by plugging
in a lamp or other
appliance.
• Check to see if
receptacle is connected
to a light switch which
turns power off when
you turn out the lights.
• Move charger and battery
to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
• The charger will not
charge a battery pack if
the pack temperature is
below approximately
32°F (0°C) or above
140°F (60°C). The
battery pack should be
left in the charger and
the charger will begin to
charge automatically
when the cell temperature
warms up or cools down.