Hansgrohe Raindance Select E 120 Green 04562 5 Serie Instructions De Montage / Mode D'emploi / Garantie page 2

7⅛"
¾"
Follow the instructions on page 5
when drilling the mounting holes.
Do not use this diagram.
Veuillez suivre les instructions de
la page 5 lorsque vous percez les
trous de fixation. Ne pas utilisez
ce digramme.
Siga las instrucciones de la página
5 al perforar los orificios de
montaje. No utilice este diagrama.
2
4¾"
max. 4⅛"
⅞"
English
Technical Information
Max. flow rate
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, profes-
sional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The screws and anchors included with this
set are suitable for use in a tile or other solid
surface wall. They are not suitable for use
in an acrylic or fiberglass shower enclosure.
Please contact the manufacturer of the
enclosure regarding recommended mounting
locations, reinforcement requirements, and
mounting hardware.
• The wallbar is a showerhead support
only. It must not be used as a grab
bar.
• This unit does not include a wall supply.
It must be used with Hansgrohe model
27458xx3 or another approved supply that
complies with ASME A112.18.1/CSA B125.1
including ASME A112.18.3.
• The handshower is intended for use with an
automatically compensating valve rated at
2.0 GPM (7.5 L/min) or less.
• To prevent scald injury, the maximum output
temperature of the shower valve must be
no more than 120°F.In Massachusetts, the
maximum output temperature of the shower
valve can be no higher than 112°F.
• Keep this booklet and the receipt (or other
proof of date and place of purchase) for
this product in a safe place. The receipt is
required should it be necessary to request
warranty parts.
2.0 GPM