Greencut PP650X Manuel D'utilisation page 57

ASSEMBLY
CONNECTING THE THROTTLE AND SWITCH
1. Remove the air filter cover.
2. Thread the "adjusting nut" counterclockwise (clockwise) away from the end of the cable.
3. Thread the "lock nut" counterclockwise (clockwise) away from the end of the cable.
4. Slide the "throttle cable" in and through the "gap".
5. Connect the end of the "throttle cable" to the "cable fixing accessory".
6. Screw the "lock nut" clockwise (to the left) onto the clamping plate until it is flush with the "gap".
7. Using a wrench, tighten the throttle "adjusting nut" until it snaps against the "lock nut" and the "stay".
8. Connect the accelerator cables. The colors of the wires may or may not match, no matter how they are
connected.
MOUNTING THE HANDLE
Place the anti-vibration rubber and the two parts of the handle at the desired height and secure them with the four
bolts.
MOUNTING THE BARS
Steps to follow:
1. Release the clamping handle (2) until the accessory bar snaps in gently.
2. Pull out the safety pin (1) and push the bar into the joint
until it reaches the maximum depth. Make sure the drive
rod fits properly into the power take-off shaft drive.
3. Turn the accessory bar until the safety pin snaps into the
accessory bar housing.
4. Tighten the lever (2) until you have checked that the
accessory bar is securely fastened.
2
57
EN
1