Conrad 75 21 68 Notice D'emploi page 34

Jumper 2 (signal sounds)
1 2
ACTIVATED
B
1 2
DEACTIVATED Insert jumper B to position 2 to deactivate the sig-
B
Jumper 3 (determine mode for relay output)
1 2
The relay con- After an alarm case, the relay contact remains tact
C
remains
closed
1 2
The relay con-
C
tact remains
closed for about reset (for this, the mode selection switch at the
3 minutes
34
All manuals and user guides at all-guides.com
a) When alarm zone 2 triggers, the system issues
short signal sounds by the internal signalling
device while the entry delay is active.
b) The alarm system emits a short signal sound
after the end of the exit delay and arming of the
alarm zones.
nal sounds.
permanently
reset (for this, the mode selection switch at the
front must be set to "OFF").
12V/DC are applied to the connection terminals 6
and 7.
After an alarm case, the relay contact remains
closed for about 3 minutes until the alarm is
front must be set to "OFF")..
12V/DC are applied to the connection terminals 6
and 7.
closed until the alarm is