Munchkin Steam Guard Mode D'emploi page 5

To Sterilize
• CHECK THAT YOU HAVE ADDED THE CORRECT AMOUNT OF WATER
(7 fl. oz.) Failure to add enough water may cause damage to this product and/or
your microwave. Adding too much water may mean your items are not properly
sterilized.
• Clip the lid on using the side catches and place into microwave.
• See TABLE A for microwave wattage and timings. Do not exceed these times.
IMPORTANT: WAIT AT LEAST TWO MINUTES BEFORE REMOVING STERILIZER
FROM MICROWAVE. This will complete the sterilization cycle and allow the unit
to cool slightly.
• After the unit has cooled, the lid can be easily removed by unclipping the side
catches one at a time.
• After each cycle, drain the excess water from the unit and rinse to prevent
limescale build-up.
• Items will remain sterile in the sterilizer for up to three hours providing the lid is
not removed.
• The Munchkin Steam Guard
discolor components.
TABLE A
ALWAYS ADD 7 FL. OZ. OF WATER (PREFERABLY DISTILLED*)
WATTAGE
1100 – 1850W
850 – 1000W
500 – 800W
*Distilled water reduces mineral deposits.
To clean sterilizer unit
• Lid, tray, tongs and base are top-rack dishwasher-safe.
™ Sterilizer is dishwasher safe. Food colorings may
FULL POWER
2 min
4 min
6 min
COOLING TIME
2 min
2 min
2 min
4