6. Arrange the teats and rings onto the small double branches on the base of the appliances (f). Put the caps on the little
branches at the top of the tree assembly (g).
Please find on page 2 how to place the different kinds of bottles.
7. Place the lid onto the appliance.
8. Plug in the steriliser to mains power, press the On/Off button (j), then the sterilisation start button (k).
9. The steam will go out through the steam branches (e), the central trunk (d) and the bottom of the appliance, ensuring a
complete sterilisation.
10. A power indicator will light up, showing that the steriliser is working. When the sterilisation cycle is complete, an alarm
will sound and the sterilisation indicator (k) will turn off. However, the steriliser is still powered on until the On/Off switch
(j) is switched off.
11. Open the lid thanks to its handle (a) and remove the bottles carefully: they will be very hot.
12. Always allow the appliance to cool between the cycles or prior to handle the bottles and accessories.
You can adapt the configuration of the tree depending of the accessories you need to sterilise (see page 4). The central
trunk (d) and all the branches are removable so that you can get the white base (h) alone to sterilise big accessories such
as breast pumps.
To remove the branches, press them towards and pull them up.
Cleaning
- Never submerge the appliance in water, and don't fill it right up with water.
- Use a slightly damp cloth to clean the inside and outside.
De-scaling
Do not use any de-scaling products.
Depending on how hard the water used is and after a certain period of time, a layer of scale may build up in the tank. In
order for the sterilizer to work properly, the tank needs to be de-scaled regularly.
Proceed as follows: mix 100 ml hot water with 100 ml white vinegar and pour it all into the tank (n). Leave to act for 30
minutes then empty the appliance. Then use a damp cloth to clean it.
10
ADJUST THE STERILISER CONFIGURATION
MAINTENANCE
TURBO STEAM ELECTRIC STERILISER • Instructions for use