Baby Jogger City Go Mode D'emploi page 22

All manuals and user guides at all-guides.com
INSTALLATION IN THE VEHICLE
WARNING
•DO NOT route the vehicle belt using any
other path when using this child seat.
•DO NOT use 2 point vehicle belt to
install this child seat.
•ONLY install this child restraint rear-facing
on forward-facing vehicle seats.
17 Place the child restraint rear-facing on the
vehicle seat and make sure the handle is in
specified position. The child will face the rear
of the vehicle.
18 Insert into the buckle until you hear a click.
Make sure the vehicle seat belt and the buckle
are in line with each other. Contact the Baby
Jogger if in doubt about this point.
19 Route the vehicle shoulder belt around the
back of the child restraint and through the
shoulder belt guide.
Note: If vehicle shoulder belt is too short, move
vehicle seat as far back as possible and
lower the seat belt height. If the vehicle belt
is still too short, try another seating position.
18