Publicité
Les langues disponibles
Les langues disponibles
1. Remove the hoses and undo the screws on the back of the washing
machine. Remove the two angular pieces.
2. Slide the angular pieces onto the groove in the blocking rod; before
doing so, rotate the right angular piece to the opposite side.
3. Use the angular pieces to rotate the blocking rods by 90° and pull
them out.
4. Cover the two holes through which the blocking rods were inserted
with plastic plugs, and redo the screws that you undid in step 1.
The plastic plugs are supplied in the bag with the washing machine
instruction manual.
MOVING AND TRANSPORTING AFTER INSTALLATION
i
If you wish to move the washing machine after it has been installed, the angular pieces and at least one blocking rod
have to be re-installed to prevent vibration damage to the washing machine during transport (see previous page). If you lost
the angular pieces and the blocking rods, they can be ordered from the manufacturer.
After transport, the washing machine should be left to stand still for at least two hours before it is connected to the
power mains, so that it can reach room temperature. The appliance should be installed and connected by a trained technician.
Carefully read the instructions for use before connecting the washing machine. Repairs or warranty claims resulting
from incorrect connection or use of the washing machine shall not be covered by the warranty.
REQUIRED SPACE FOR INSTALLING
WARNING!
• Stability is important to prevent the product from moving across the installation site! Make sure to level the appliance
and install it on a stable base in longitudinal and traverse direction by screwing the adjustable feet up or down.
• Make sure the appliance is not standing on the power cord.
• Observe the minimum required clearances from the walls as indicated in the figure.
i
The room in which the appliance is placed must meet the following requirements:
1. Dry, level and stable solid base
2. Avoid direct sunlight
3. Sufficient ventilation
4. Room temperature is above 0°C
5. Keep far away from heat sources such as coal, gas or wood burning appliances.
WASHING MACHINE INSTALLATION CLEARANCES
The washing machine may not be in contact
with a wall or adjacent furniture. For optimum
washing machine operation, we recommend
observing the clearances from the walls as
indicated in the figure.
In case of failure to observe the minimum
required clearances, safe and correct washing
machine operation cannot be ensured.
Moreover, overheating can also occur
(figures 1 and 2).
i
Installing the washing machine under
a countertop is not recommended.
38
•
English
25 mm
1
25 mm
2
50 mm
Publicité
