Publicité
Les langues disponibles
Les langues disponibles
Do not connect the appliance to the power mains using an
external switch device such as a programme timer, or connect
it to a power mains that is regularly switched on and off by the
power supply provider.
• Do not connect the appliance to an electrical outlet intended for
an electric shaver or hair dryer.
• The mains plug must be accessible after installation.
Never use an extension cord or multiple plugs for making
a connection.
Do not pull the plug out of the power socket if there is
flammable gas around.
Never pull out the plug with wet hands.
Always unplug the appliance when it is not being used and
close the water tap.
• Connection to water and power supply has to be executed by
an adequately trained technician or expert.
• Any repair and maintenance pertaining to safety or performance
should be done by trained experts.
• In case of a defect, only use approved spare parts by authorised
manufacturers.
• In case of incorrect appliance connection, incorrect use, or
servicing by an unauthorised person, Inventum will not be
responsible for any damage, as such damage will not be covered
by warranty.
WATER INSTALLATION
• The appliance is equipped with a single inlet valve and can be
connected to the cold water supply only.
• To connect the appliance to the water supply, make sure to use
the supplied water supply hose and gaskets.
The water pressure has to be between 0.05 and 0.8 MPa
(0.5 - 8 bar).
• Always use the supplied new water supply hose to connect
the appliance to the water supply; do not reuse an old water
supply hose.
• The end of the water discharge hose should reach into a water
drain line.
32
•
English
Publicité
