Flex ADM 30 smart Notice D'instruction D'origine page 13

513.091_ADM30_smart.book Seite 13 Donnerstag, 22. April 2021 9:36 21
Checking precision
It is recommended to check the device regularly to
ensure that it is always precise.
If the precision deviates from the permitted tolerance
range, the device must be taken to a customer service
workshop authorised by the manufacturer.
Have the device adjusted by authorised technicians
only.
The steps required to check the precision are explained
at the end of these instructions on the illustrated pages.
See from page 140.
Maintenance and care
Observe the following instructions:
– Handle the measuring instrument with care and
protect it from impacts, vibrations and extreme
temperatures.
– Do not touch the receiver lens with your fingers.
– Clean the lens with a soft, dry cloth only.
– Never submerse the measuring instrument in water
or other liquids.
– Keep the measuring instrument in a dry place.
– Have the measuring instrument repaired by qualified
technicians and with original spare parts only.
This ensures that the safety of the measuring
instrument is maintained.
Disposal information
EU countries only:
Do not dispose of electric power tools in
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and Electronic
Equipment and transposition into national law, used
electric power tools must be collected separately and
recycled in an environmentally friendly manner.
Raw material recovery instead of waste
disposal.
The device, accessories and packaging should
be recycled in an environmentally-friendly manner.
Plastic parts are identified for recycling according to
material type.
ADM 30 smart
13