Zephyr Essentials Modena Wall ZMO-E30AS Guide D'utilisation, D'entretien Et D'installation page 15

SURFACE MAINTENANCE:
Clean the hood surface periodically with hot soapy water and clean cotton cloth. Do not use corrosive or
abrasive detergent, or steel wool/scouring pads which will scratch and damage surface.
For heavier soil use liquid degreaser.
After cleaning it is recommended that you use non-abrasive stainless steel polish/cleaners, to polish and
buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
Do not use any product containing chlorine bleach. Do not use "orange" cleaners.
Aluminum Mesh Filters
The aluminum mesh fi lters installed by the factory are intended to fi lter out residue and grease from
cooking. They need not be replaced on a regular basis but are required to be kept clean.
After 30 hours of use the words "clean mesh fi lter" will illuminate on the control screen indicating time to
clean the metal mesh fi lters. Refer to instructions on page 12 on how to reset the indicator. Filters may
need to be cleaned more depending on cooking habits.
Remove and clean by hand or in dishwasher on low heat. Spray degreasing detergent and leave to soak if
heavily soiled.
Dry fi lters and re-install before using hood.
Removing Aluminum Mesh Filters
1. Push in on spring loaded handle
2. Pull down on fi lter hande to remove fi lter
Should fi lters wear out due to age and prolonged use,
replace with following part number:
Hood Model:
ZMO-E30AS, ZMO-M90AS
Part No. Qty to Order
50200042 1
13