Toparc UNI 2.0 RE Manuel D'utilisation page 11

REDUCED SUCTION
MACHINE MAINTENANCE
Scheduled maintenance table
INSPECTION OR
MAINTENANCE TYPE
PURIFIER GENERAL
1
CHECKUP
2 CLEANING
MACHINE GENERAL
3
CHECKUP
BOLT TIGHTENING
4
INSPECTION
FILTERS' CLOGGING
5
INSPECTION
FUME EXTRACTOR
6
INSPECTION
WHEELS REPLACEMENT
7
NOTE A
The frequency of cleaning is strongly influenced by the concentration of dust in the air, the extracted air, the work ope-
ration and by the work environment. It is necessary that the user defines cleaning intervals so the machine stays clean
and that the accumulated matter on the static parts is no thicker than 5mm .
NOTE B
Filter replacement is signaled by the machine. In general, it is recommended to check the machine regularly to maintain
higher extraction performance. Thus it is recommended to replace the filter at the recommended intervals or at least
once a year, as filters deteriorate over time.
NOTE C
Maintenance must be performed regularly to monitor the condition of the engine., Make sure to check the whole
machine, this could reveal damages or faults.
NOTE D
This is the estimated lifetime of the anti vibration seals, this means that external causes such as higher than average
vibrations may require an earlier replacement.
It is also recommended to replace the wheels at the recommended interval, even if there is no apparent damage.
FUME EXTRACTOR UNI 2.0 RE
+ ARM 160/3
Obstructed filters
Air leak
Turbine out of balance
METHODS FREQUENCY
VISUAL DAILY
MANUAL See note A
VISUAL 150 HOURS
MANUAL 150 HOURS
VISUAL OR 600 HOURS See
MANUAL note B
MANUAL See note C
MANUAL 40000 HOURS
see note D
Check the filters' state of health
and the control panel. If necessary,
replace the filters.
Check the coating. If possible, repair
with silicone.
Check the turbine and the cleanliness
of the blades. Remove the fan and
clean the blades thoroughly.
INSPECTION DATE AND NAME OF THE INSPECTOR
1 2
Translation of the original instructions
3 4
EN
5
11