Toparc UNI 2.0 RE Manuel D'utilisation page 10

Removing the filters must be done in the following order, starting with the lowest filter; which has
a frame that can be used as a bearing point in order to remove the filter. The other filters can then
be removed easily as they are not pressurised anymore.
FILTER DETAILS
First filtration step : Metal filter (Clean once a week)
Dimensions
Filtration material
Can regenerate
Behaviour under flame
Second filtration step : Ondulated filter cell (Clean once every 2 weeks)
Dimensions
Filtration material
Can regenerate
Behaviour under flame
Third filtration step: EPA rigid bag filter (Clean once a month)
Dimensions
Filtration material
Can regenerate
Behaviour under flame
TROUBLESHOOTING
PROBLEM
STARTING PROBLEM
NO STARTING
THE MACHINE ABSORBS MORE CUR-
RENT THAN SHOWN ON THE PLATE/
INSTRUCTION MANUAL
EXCESSIVE VIBRATION
10
FUME EXTRACTOR UNI 2.0 RE
+ ARM 160/3
mm
mm
mm
CAUSE
Low power supply voltage
No power supply
No power supply
Engine fatigue
Engine rotates at low speed
Moving parts out of balance
Faulty anti vibration system
Translation of the original instructions
FIG II
A
485x485
Aluminium filter
Yes (washable)
Non-flammable
490x592
Polyester filter
Yes (shaking)
DIN 53438 F1
490x592
Polyester filter E12
No
M1
SOLUTION
Check the plate and the power sup-
ply.
Check the connection to the mains
and/or the socket
Check the connection to the mains
and/or the socket
Replace the extraction fan
Check the power supply.
Check the engine.
Check the moving parts
Check the fixation of the anti vibra-
tion systems and that they operate
properly
EN
B C