Domo MB010 Mode D'emploi page 45

BEFORE THE FIRST USE
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth
and the inside with a wet, lukewarm cloth.
· Avoid placing the cabinet in a narrow recess or near any leave source, direct sunlight, or
moisture.
· Let air circulate freely around the cabinet. Keep the rear of the refrigerator 13 cm away
from the wall.
· Select a place with a strong, level floor. One can level the appliance using adjustable legs.
The adjustable legs can be adjusting by screwing them in or out of the appliance.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly
on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated
on the rating label of your appliance corresponds to the voltage in your home. A different
voltage could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible for damages that
may occur as a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 8 hours before turning it on. This way the refrigerant
can settle.
· Allow the appliance to run empty for 24 hours so the compartment can cool to the
appropriate temperature.
· This appliance is designed to operate in ambient temperature between 16°C and 38°C.
If these temperatures are exceeded, i.e. colder or warmer, the appliance will not operate
correctly.
· The appliance may only be used indoors.
· The freezer makes noise when the compressor pumps the coolant. This is normal.
· Make sure that the air can circulate around the refrigerator. Spacers have been provided
with the refrigerator to ensure that it cannot be pushed right up against the wall. Fasten
these to the back of the refrigerator.
www.domo-elektro.be
45
Domo MB010