Publicité
Les langues disponibles
Les langues disponibles
NOTE: If the fan motor plug is
connected to the fan housing
receptacle, unplug so the blower
assembly can be completely removed.
2.
Continuous Ventilation: For two speed fans wired for continuous ventilation, connect the
White wire of the fan to the White (Neutral) wire from the power source. Connect the ground
wire from the house to the green wire from the fan housing. Run 2 wires from a properly
grounded wall switch (not included) to the fan. Connect the Blue wire of the fan and one
wire from the wall switch to the Black wire (Hot) from the power source. Connect the other
wire from the wall switch to the Black wire of the fan. Closing the switch will change from
normal to high speed (Figure 8).
Supply from
house
Ground (Green or Bare)
Figure 8
3.
Intermittent Ventilation: For two speed fans wired for intermittent ventilation with the
recommended AKS2 Switch (not included). Connect the White wire of the fan to the
White (Neutral) wire from the power source. Connect the ground wire from the fan to the
ground wire from the power source. Properly ground the switches. Run a wire from the
Blue wire in the fan to the Common terminal (Black Screw) of the AKS2 Switch. Connect
the Black wire from the power source to the silver terminal on the bottom of the AKS2
Switch. Connect the Black wire from the fan to the silver terminal on the top of the AKS2
Switch. The Bottom switch will turn the fan on & off, the top switch will change between
high and low (Figure 9).
Supply from house
Ground (Green or Bare)
Hot
(Black)
Switch
Figure 9
NOTE: Unit must be grounded according to all local and national codes.
4.
Reinstall both the wire compartment cover and the fan's venturi by reversing the
instructions in Step 1b of Section 5 Wiring. Make sure all wires are contained within the
wire compartment.
A210952011 Rev. A 8-12
All manuals and user guides at all-guides.com
Screw
Compartment
Figure 7
Hot (Black)
Neutral
(White)
Blue
Black
Switch
Neutral (White)
Black
Blue
SECTION 6
Wire
Completing the Installation
Cover
1.
Plug the fan's quick connect motor cord into the receptacle located on the wire compart-
ment cover. The cord will only fit one way into the receptacle (Figure 10).
Figure 10
2.
Install the grill by squeezing the two ends of the springs together and installing them up
into the slots on the fan's housing. Push the grill up into position (Figure 11).
Blue
Figure 11
3.
Restore power and test your installation.
SECTION 7
Use and Care
CAUTION:
STARTING INSTALLATION.
Cleaning the Grill: Remove grill and use a mild detergent, such as dishwashing liquid,
1.
and dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry grill before reinstalling. Refer to instructions in Section 6 Finishing the
Installation, to reinstall grill.
2.
Cleaning the Fan Assembly: Wipe all parts with a dry cloth or gently vacuum the fan.
NEVER IMMERSE ELECTRICAL PARTS IN WATER.
Fan
www.airkinglimited.com
Screw
MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE
Wire
Compartment
Cover
3 of 12
Publicité
