General Safety Warning - NOCCHI K Série Manuel D'utilisation Et D'entretien

GB
Ch. 1 - Features
Ch. 2 - Transportation and storage
Ch. 3 - Limitations
Ch. 4 - Motor assembly
Warnings for the safety of individuals and things.
Please pay careful attention to the following signs and indications.
DANGER
Electric shock
risk
DANGER
Risk of bursting
DANGER
WARNING
WARNI NG: Before installing this pump read this manual carefully. Any damage caused by
failure to observe any directions in this manual will not be covered by warranty.
CH. 1 - FEATURES
K-SERIES, SCM 4 Plus®, SCM 4 HF and SA 6 pumps can be supplied with or without electric motor. This booklet
supplies all the information concerning the use and maintenance of these machines.
K-SERIES, SCM 4 Plus®, SCM 4 HF and SA 6 pumps are submersed. The multi-stage pumping unit is directly coupled
to the submersed electric motor.
CH. 2 - TRANSPORT AND STORAGE
Each machine is carefully tested and packed during the assembly phase.
On receiving the pump, customers will have to verify: that the product complies with the data quoted in the order; that
is has not suffered damages during transportation. All damages should be immediately reported to the distributor
within 8 (eight) days from the date of purchase.
Don't disperse and/or throw the packaging away and take all possible measures to re-use it and recycle it.
Before transporting the unit, check the following data:
- weight of the pump (or the pump end)
- overall dimensions
- lifting points
The pump (or the pump end) has to be transported with equipment suitable to its weight and dimensions. Only pumps
(or units) with a weight below 20 Kg can be transported manually.
The units have to be stored in closed, dry and ventilated areas avoiding excessively low temperatures. If the units
have to be stored for long periods of time (above 12 months) or in presence of low temperatures, it is necessary to
rotate the shafts and the hydraulic unit at least once a month. Protect the terminals of the cables from humidity,
making sure that these are not bent with curves above 6 times their diameter. If the single components are stored
individually, protect the rubber parts and the thrust bearings from direct sun light.
CH. 3 - LIMITATIONS
K-SERIES, SCM 4 Plus®, SCM 4 HF and SA 6 pumps are designed to pump clean water (for the food industry).
6
CONTENTS

GENERAL SAFETY WARNING

Warns that the failure to follow directions may cause electric shock.
It indicates that the failure to comply with the instruction given can
cause an explosion.
Warns that failure to follow directions could cause serious risk to
persons or things.
It indicates that the failure to comply with the instruction given can
damage the pump.
Ch. 5 - Electric pump installation
Ch. 6 - Electric connection
Ch. 7 - Starting the unit
Ch. 8 - Maintenance and troubleshooting