Connection To The Electric Supply - Agilent Technologies MS120 Mode D'emploi

Section II

Connection to the Electric Supply

It is recommended to connect the pump to the power supply through a dedicated
CAUTION!
safety switch on the main electrical panel of the installation, or in proximity of
the power supply connection point.
WARNING!
The pump must be installed in a way that allows an easy interruption of the
line voltage.
Power supply cord: The correct cable for electrical wiring is a three
wires (Ph+N+Earth) cable. The wire section has to be at least 2 mm
(AWG14).
MS120 Single Stage Rotary Vane Pumps User Manual/87-900-150-01 (C.00)
Technical Information
Section II
170/193
5
2