Publicité
Les langues disponibles
Les langues disponibles
8.8
CHANGE TO THE EDGING MODE
You can change the machine to a well groomed edger for
edging patios, driveways and walkways or other areas.
1. Stop the machine.
2. Loosen the screws.
3. Push on the rotating handle latches and turn the trimmer
head 180 degrees until the trimmer head locks into
position.
1
4. Release rotating handle latches (1).
5. Insert the screws into the shaft.
6. Tighten the screws.
9
MAINTENANCE
IMPORTANT
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
IMPORTANT
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
IMPORTANT
Use only the replacement parts and accessories of the initial
manufacturer.
9.1
GENERAL INFORMATION
IMPORTANT
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
NOTE
English
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
9.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
9.3
REPLACE THE SPOOL
1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
Cover
Spool
3. Remove the spool.
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot on the
new spool, and is extended approximately 5 in. before you
install the new spool.
9
NOTE
EN
Publicité
