Publicité
Les langues disponibles
Les langues disponibles
EN
5. Put the end of the cutting line through the eyelet.
6. Extend the cutting line to release it from the guide slot in
the spool.
Line exit hole
7. Push the tabs and install the spool cover onto the spool
housing.
8. Push the spool cover until it clicks into position.
9.4
REPLACE THE CUTTING LINE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.065" (1.65 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Insert the line into the anchor hole of the spool.
NOTE
NOTE
English
4. Wind the cutting line around the spool tightly in the
indicated direction.
5. Put the cutting line in the guide slot.
6. Do not wind the cutting line beyond the edge of the spool.
10
TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
transportation and storage.
10.1
MOVE THE MACHINE
When you move the machine, you must:
•
Wear gloves.
•
Stop the machine.
•
Remove the battery pack.
10.2
STORE THE MACHINE
•
Remove the battery pack from the machine.
•
Make sure that children cannot come near the machine.
•
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
•
Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
10
WARNING
Publicité
