Publicité
Les langues disponibles
Les langues disponibles
Technical data
Working temperature
Power Supply
lntegrated radio receiver
Antenna
Sensitivity of reception
Setting time with interference-free
Summertime/wintertime
Time storage
Battery
Size clock
Size clock face
Weight
Subject to technical modifications
16
–5° C to +55° C
1 x 1.5 Volt RAM
DCF 77 at 77.5 kHz
Internal ferrite antenna
≤ 70 μV/m
3–5 minutes reception
Automatic adjustment
Effective in case of reception
interference
Alkaline RAM battery 1.5 V,
rechargeable RLR6AA
13 x 9.5 x 5cm
8 cm
200 gr. (with Battery)
Service – frequently asked questions
Question
Answer
(1) Restarting the clock
Remove the battery from the battery compart-
ment.
Place the clock on a support with Its face facing
downwards, and then briefly (for approx.
2 seconds) insert the battery the wrong way
around (with reversed polarity). Then immedia-
tely insert the battery the right way around again.
(2) The hands of the clock
Restart the clock (1). The battery is almost empty:
turn continuously
check the voltage. Alternately, the clockwork
may be faulty, in which case you should send the
clock to the Service Department.
(3) The clock does not set
Remove the clock from the field of influence
itself
of possible sources of interference. The clock
should be more than 1 m away from television
sets, computers, monitors etc. Then restart the
clock (1).
(4) The clock remains
The clock takes up to 10 minutes to receive the
stopped at 4, 8 or 12
radio signal and set itself. In case of poor recepti-
o'clock and does not
on conditions, this may even take a whole night.
set itself
(5) The clock displays the
Restart the clock (1).
wrong time
(6) Battery
Special solar clock battery with rechargeable
alkaline-manganese cell, available from
info@filius-zeitdesign.de
Do not use disposable batteries!
17
Publicité
