Filius Zeitdesign 230203 Mode D'emploi page 8

Alarm Functions
Setting the alarm time
Set the alarm time by turning the time setting wheel (seen from the back of the
alarm clock) in direction of the arrow.
Alarm
The alarm has two crescendo steps and two different intervals. This means that
the alarm volume gradually becomes louder.
Activating the alarm
Push the "Alarm on/off" switch at the side upwards. The alarm activation is
indicated by a red window on the clock face.
Alarm interruption (snooze function)
Briefly press the top button. The alarm signal is interrupted for approximately
5 minutes and then sounds again. The snooze function can be repeated for
as long as the alarm is activated until 45 minutes after the alarm time. The
alarm signal is automatically exited after 2 minutes, if it is not interrupted or
deactivated.
Switching off the alarm signal
In order to switch off the alarm, press the "Alarm on/off" switch at the side
downwards. The red window on the clock face is no longer visible.
Illumination
With every first further alarm the lighting is switched on automatically for 5
seconds. For the duration of every button press the clock face lighting is activa-
ted, and it remains activated for approx. 5 seconds.
14
Changing the battery
The energy output of the internal solar module is stored in the special battery
pack. This works with normal lighting conditions in the living and sleeping
areas. The special battery pack is cadmium-free and will be reliable for appro-
ximately 8 years. The battery fitted is protected against overcharging and total
discharge by overcharging electronics and co-ordination of the solar module
and movement.
Please note that if you do not place the alarm clock to a source of light, the
lifetime of the battery pack will be reduced, because it cannot be recharged
without light from the solar module. If you find that the performance of the
battery pack decreases (e.g. the illumination becomes weaker), please put the
solar module under bright light (not direct sunlight!) for several hours.
In the rare event that you should nonetheless need to change the special
battery pack it is important to use only a rechargeable alkaline RAM battery of
AA size.
For the recharging the special battery pack, you should only use a special
battery charging unit (suitable for RAM cells).
15