GETTING STARTED
REMOTE SENSOR INSTALLATION
1. Step applicable only to THGR122N:
Using a Philips screwdriver, open the battery
compartment cover.
2. Slide channel switch to select channel 1. Ensure
you use a different channel for the other sensors
(2, 3).
3. Insert the batteries, matching the polarities.
4. Press RESET after each battery change.
5. Replace the battery compartment cover.
MAIN UNIT INSTALLATION
1. Remove the battery compartment.
2. Insert the batteries, matching the polarities.
3. Press RESET after each battery change.
The battery icon
areas:
AREA
Main unit
environment area
Remote sensor
environment area
RAR502-OSEU_IM_EN_R3.indd 4
All manuals and user guides at all-guides.com
may appear in the following
MEANING
Main unit batteries low
Remote sensor batteries
low
NOTE
We recommend that you use alkaline batteries with
•
this product for longer usage and lithium batteries in
temperatures below freezing.
Batteries should not be exposed to excessive heat
•
such as sunshine or fire.
SYNCHRONISING AND PLACING SENSORS
The main unit will automatically search for new
sensor reset within the last 30 minutes. If unit failed to
synchronise with remote sensor, reset both the main
unit and sensor or try selecting a different channel (and
press RESET).
The remote sensor reception icons will show the following
status:
ICONS
and "--.-"
Place the remote sensor within 30 m (98 ft) from the
main unit.
4
MEANING
Main unit is searching
for sensor(s)
A sensor has been
found and logged on
No sensor found
15-8-21 下午3:32