Kenwood Kmix SJM020A Serie Mode D'emploi page 3

All manuals and user guides at all-guides.com
to use your kettle
1 Fill the kettle through either the
spout or lid. The water level must be
between 'MAX' and 'MIN'.
Be economical: do not boil more
●
water than you need.
To improve the quality of your drinks
●
always use fresh water.
Empty the kettle after each use.
●
2 Check the lid is closed. Close the lid
by pushing down on the finger pad
area .
3 Plug in and switch on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
If you experience problems
●
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
"descaling".
Your kettle is fitted with a filter to
●
hold back limescale particles.
If you find drops of water under your
●
kettle, don't worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
●
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
care and cleaning
Before cleaning, unplug your kettle
●
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then dry.
●
Do not use abrasives - they will
scratch the metal and plastic
surfaces.
the inside
Even though your kettle comes with
●
a filter, you still need to clean the
inside (and the filter) regularly.
the filter
1 Open the lid.
2 Slide the filter out .
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 Slide the filter back in to refit
descaling
Regular descaling of the flat element
●
will improve the performance of your
kettle. If the kettle is not descaled
regularly the build up of limescale
may result in the following:
problems may be experienced
●
with the kettle switching on and
off during use or switching off
before boiling.
the kettle may take longer to boil.
●
the flat element may be damaged.
●
Please note: Failure to descale your
kettle may invalidate your guarantee.
When limescale starts to build up on
●
the heating element, buy a suitable
descaler and descale your kettle.
After descaling, boil with fresh water
several times and discard. Clean any
descaler off the kettle - it can
damage the parts.
Some regions of the country have
●
chalky water. This makes boiled
water look cloudy and leaves a
deposit on the side of the kettle. This
is normal but can be removed with
regular cleaning.
Alternatively, to reduce limescale
●
build up, use filtered water to fill your
kettle.
3
.