Fulbat FULBOOST Mode D'emploi page 6

1. Plug the auxiliary cable to PC port 19V 3.5A of the NOMAD POWER.
2. Select the appropriate connection for your laptop and connect it on the auxiliary cable.
3. Plug the auxiliary cable with the right connection on the power supply socket
4. Press the ON button to start the charge
1. Plug the auxiliary cable (not supplied) to the 12V 12A NOMAD POWER port.
2. Plug the auxiliary cable (not supplied) to your 12V device.
3. Press the power button.
Press the power button for 3 seconds to activate the LED.
Briefly press the button to switch lighting modes.
(4 available modes: normal, flash, SOS and OFF)
This device is protected against short-circuits, overloads, deeply discharge and polarity inversions.
TROUBLESHOOTING
No response while pressing
1
the ON/OFF button
"Error" light ON on the
2
jumper cable.
"Error" light flashes red +
3
alarm beep.
The device is warm whilst
4
connected to a laptop
All manuals and user guides at all-guides.com
POWER SUPPLY
of your laptop.
FLASHLIGHT FUNCTION
PROTECTIONS
TROUBLESHOTING, CAUSES, REMEDIES
CAUSES
The NOMAD POWER is discharged.
Internal battery voltage < 11.0V.
Polarity reversal
Short-circuit
Clamps have been left connected
to the battery.
-
Charge the product (see page 4).
Charge the product.
Check that the clamps are well connected and unplug/plug back the jumper cable.
Check that the clamps are well connected and unplug/plug back the jumper
Remove the 2 clamps from the car battery in order to protect the device.
Remove laptop's battery or unplug the NOMAD POWER from the laptop for 5
minutes and plug it back again.
6
REMEDIES