Fulbat FULBOOST Mode D'emploi page 5

Emergency start function for petrol or diesel vehicles with a 12V battery.
To start a vehicle, please process as follows:
If the NOMAD POWER voltage is inferior to the vehicle voltage, the NOMAD POWER will not operate.
1
SMART
BOOSTER CABLE
2
Error
Start
3
4
Start
5
Error
6
7
All manuals and user guides at all-guides.com
STARTING THE VEHICLE
Connect the jumper cable to the NOMAD POWER connector.
If the lights "Start" and "Error" flash alternately in green and red, the
product is ready. If the red light only is ON, the internal battery voltage of
the NOMAD POWER is too low. In this event, charge your device.
Make sure the NOMAD POWER is charged by checking the number of
indicators on the device (minimum of 3 indicators ON (see page 4)).
1. Connect the red clamp to the (+) of the battery.
2. Connect the black clamp to the (-) of the battery.
If the "Start" light is green and the "Error" light turns off, everything is
ok. The green light stays ON for 30 seconds so the user has 30 seconds to
30"
go and start his vehicle.
(If no action is done during this time, the jumper cable turns itself off and
the "Start" and "Error" indicators will flash again alternately. Unplug and
plug back your jumper cable to the connector device (see step 1).
If only the "Error" indicator is turned ON, starting the vehicle is not
possible (see page 6 for more information).
Starting the vehicle: The "Error" indicator flashes red and an alarm beep
goes off.
Remove immediately the 2 clamps of the vehicle battery and unplug also
the jumper cable from of the connector.
5