WIMIUS T3 Mode D'emploi page 6

All manuals and user guides at all-guides.com
Two．Installation Projector
1.Installation method
Place the projector on a solid, stable surface or hanger, surrounding
ventilation, do not block the vents or shelter, and no shelter vents
objects within 10CM. So that theprojector and screen to maintain an
appropriate distance from the projector and screen determines the size
of the projected image. Connect the projector's power cord to a power
outlet and the projector, and the other end is connected with the AC
ground. Depending on your needs, you can place the projector on a
stable counter top forward projected onto the screen, you can also
use special hangers will be fixed on the roof playing, can also be
used behind a screen, and cast from behind the screen image.
Front
Rear
Installation Note: When forward lifting, the body can not be higher
than the projection on the edge of the screen, otherwise it will affect
the effect of adjusting the image or trapezoidal Please refer to "The
distance between the projector and the screen" section to determine
the size of the distance between the screen and the projector Place
the projector screen is on the axis of symmetry about the installation,
in order to avoid the image left and right trapezoidal distortion.
During installation, do not live operation, in order to avoid risk of
electric shock or burn the machine.Just packed projectors, the first
boot image may appear on the bottom was a trapezoidal distortion
and blur, see the "keystone correction and focus adjustment" section
later adjusted
Ceiling
Install rear hanger
Square Image
The Curtain
Axis of
symmetry
The Projector
of the curtain
5