Publicité
Les langues disponibles
Les langues disponibles
!
Non-professionals are not allowed to disassemble the thermal switch to reset.
Please contact professionals to maintain. Otherwise our company will not take
responsibility if any quality accident happens because of this.
6. TROUBLESHOOTING
Failures
The heating indicator
light is off.
No water coming out
of the hot water
outlet.
The water temperature
is too high.
Water leak.
Parts illustrated in this use and care manual are indicative only, parts provided with the
product may differ with illustrations.This product is intended for household use
only. Specifications are subject to change without notice.
NOTE:
If after making all checks, the problem persists, contact our technical service
throuhg our website:
WARNING
Reasons
Failures of the temperature
controller.
1. The running water supply
is cut off.
2. The hydraulic pressure is
too low.
3. The inlet valve of running
water is not open.
Failures of the temperature
control system.
Seal problem of the joint
of each pipe.
NOTE
www.ponjohnsonentuvida.es
8
Manual reset button
Treatment
Contact with our tecnice
service
1. Wait for restoration of
running water supply.
2. Use the heater again
when the hydraulic
pressure is increased.
3. Open the inlet valve of
running water.
Contact with our tecnice service
Seal up the joints.
(Fig.6)
V.1
Publicité
