Publicité
Les langues disponibles
Les langues disponibles
Safety and Recommendations
WARNING: Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell phone .
WARNING: Use only the power supply provided in this package . Use of a non-weBoost product may damage your
equipment .
WARNING: The Signal Booster unit is designed for use in an indoor, temperature-controlled environment (less than 150
degrees Fahrenheit) . It is not intended for use in attics or similar locations subject to temperatures in excess
of that range .
WARNING: To uphold compliance with network protection standards, all active wireless devices must maintain at least 20
inches of separation distance from inside antennas .
RF SAFETY WARNING: Any antenna used with this device must be located at least 8 inches from all persons .
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your
provider's consent. Most wireless providers consent to the use of signal boosters. Some
providers may not consent to the use of this device on their network. If you are unsure, contact
your provider.
You MUST operate this device with approved antennas and cables as specified by the
manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person.
You MUST cease operating this device immediately if requested by the FCC or a licensed
wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served
by using this device .
This device complies with Part 15 of FCC rules . Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation . Changes or modifications not expressly approved by weBoost could void the authority to operate this
equipment .
Each Signal Booster is individually tested and factory set to ensure FCC compliance . The Signal Booster cannot be
adjusted without factory reprogramming or disabling the hardware . The Signal Booster will amplify, but not alter incoming
and outgoing signals in order to increase coverage of authorized frequency bands only . If the Signal Booster is not in use
for five minutes, it will reduce gain until a signal is detected . If a detected signal is too high in a frequency band, or if the
Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that band . For a detected
oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute . After 5 (five) such
automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted
by momentarily removing power from the Signal Booster . Noise power, gain, and linearity are maintained by the Signal
Booster's microprocessor .
8
Need help?
All manuals and user guides at all-guides.com
www.weboost.com
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm
Publicité
