Publicité
Les langues disponibles
Les langues disponibles
• Peel the backing to expose the adhesive
and press the bracket onto the desired
location on the dashboard . NOTE: Be sure
the tab is positioned vertically .
• Allow the adhesive to cure for 24 hours
before you attach the Drive 3G-Flex
(Step 4) .
4 .
Attach the Drive 3G-Flex signal booster
to the Mounting Bracket . After waiting
24 hours for the adhesive on the bracket
to cure, attach the signal booster by
aligning the rectangular hole on the back
of the signal booster with the tab on the
Mounting Bracket, grasping the sides of
the signal booster, and sliding it downward
approximately ¼ inch into place .
The Mounting Bracket is designed to swivel
for more convenient viewing angles . Once
the signal booster is in place, you can adjust
the angle of the bracket by loosening the
knurled nut, applying gentle pressure to the
top or bottom of the signal booster, and then
tightening the nut when the desired angle is
achieved .
4
Need help?
All manuals and user guides at all-guides.com
Alternative mounting
options available. Contact
Customer Support at 866-
294-1660 for details.
www.weboost.com
5 .
Attach the antenna cable to the antenna
connector on the bottom of the signal booster .
The antenna cable must be connected before
going to the next step .
6 .
Power up your Drive 3G-Flex . Connect
the power cable to the mini-USB port on
the bottom of the signal booster . Connect
the other end of the power cord to the DC
adapter and insert the adapter into the
vehicle 12V DC power source . Use only the
supplied weBoost power supply . While the
Drive 3G-Flex may remain on, leaving the
Drive 3G-Flex on in a vehicle when it is not
running may discharge the battery in a day
or two . Also note that some 12V DC power
sources are shut down when the vehicle
ignition is turned to off .
Alternative Mounting for Weak Signal Areas
If you know you drive through particularly weak
signal areas, you may want to mount your signal
booster closer to your cell phone when in use .
To do this, attach a strip of double-sided Velcro
(available at most hardware or fabric stores) to
the back of the Drive 3G-Flex and to your center
console of your vehicle . Press Drive 3G-Flex to
console .
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm
Publicité
